Beurer MG 156, Инструкция по эксплуатации

Страница: 7 / 20

7
10. Disposal
NOTICE:
• Dispose of the device, components and optional
accessories according to applicable local regula-
tions. Unlawful disposal may cause environmen-
tal pollution.
If you have any questions, please contact the local
authorities responsible for waste disposal.
11. Troubleshooting
NOTICE:
• Repair or replacement is our only responsibility
and your only remedy under this written warranty.
Problem Cause Remedy
The device
is very
loud during
massage.
The seat cover
is not fully in
contact with the
base.
Ensure that the seat
cover is supported
over its entire area.
Massage
stopped.
The preset maxi-
mum period of
operation has
elapsed.
Let the device cool
down for at least
15 min. before
using again. Switch
the device on again.
Massage
stopped.
The connection
to the electrical
outlet has been
interrupted.
Check the plug
connection and the
contact of the AC-
Adapter with the
electrical outlet.
No
massage.
Appliance not
connected to the
power supply.
Make all connec-
tions and switch on
the device.
Device not
switched on.
Press the Massage
button.
No
massage.
Massage device
defect.
Does not work.
Switch off and un-
plug the unit imme-
diately and contact
Beurer customer
service. (Please see
warranty for service
contact)
12. Technical specifications
The following symbols are used on the packaging and
on the nameplate of the device and accessories.
Dimensions
(LxWxH)
38.19” x 17.72” x 1.18”
(970 x 450 x 30 mm)
Device weight 21.16 oz (600 g)
Mains connection 100 – 240 V ~; 50 /60 Hz; 0.5 A
Car adapter
12 V DC; 3 A max.
Subject to technical modifications.
Symbols Key
WARNING! Read safety information to
avoid serious injury.
Device protection class 2
Indoor use only!
Note:
If the device is used outside of the specifications, prop-
er function is no longer guaranteed! We reserve the
right to make technical changes to improve and further
develop the product.
ELECTROMAGNETIC COMPATIBILITY
• The device complies with current specifications with
regard to electromagnetic compatibility and is suitable
for use in all premises, including those designated
for private residential purposes. The radio frequency
emissions of the device are extremely low and in all
probability do not cause any interference with other
devices in the proximity.
• It is recommended that you do not place the device on
top of or close to other electronic devices. Should you
notice any interference with other electrical devices,
move the device or connect it to a different socket.
• Radio equipment and TV interference may affect the
operation of this device.
13. FCC Statement
The device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, in-
cluding interference that may cause undesired operation.
Changes or modifications to the product not expressly
approved by the manufacturer could void the user’s au-
thority to operate the equipment.
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in ac-
cordance with the instructions, may cause harmful in-
terference to radio communications. However, there is
no guarantee that interference will not occur in a partic-
ular installation. If this equipment does cause harmful
interference to radio or television reception, which can
be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.