Beurer GL30 mg/dL, Инструкция по эксплуатации

Страница: 24 / 32

Beurer GL30 mg/dL 22
Expected results
At room temperature the test results with the control solution should be within the range
printed on the test strip container for approximately 95% of all tests.
WARNING
The results range printed on the test strip container is only applicable to the
control solution.
It is not a recommended value for your blood glucose
level.
If the results are outside the specified range, check the following possible causes:
Cause Measure
The code number on the display is not
the same as that of the test strip con-
tainer. Code the monitor (see "4.3 Checking
code number (coding)" page 14).
•
You did not dispose of the first drop of
control solution
•
The top of the vial was not wiped
clean.
•
The vial was not shaken sufficiently.
Correct the cause and repeat the test.
Control solution has expired or is con-
taminated. Repeat the test with a new vial of control
solution.
Control solution or monitor is too warm or
too cold. Bring control solution and monitor to
room temperature (+20°C to +25°C) and
repeat test.
Damaged test strips Repeat the test with a new test strip.
Old test strips Open a new test strip container. Repeat
the test.
A problem with the monitor Contact our Customer Service depart-
ment.
WARNING
If you receive repeated results outside the specified range with the control
solution,
do not continue using the system to measure your blood glu-
cose level . Contact our Customer Service department.