Beurer BM 45, Инструкция по эксплуатации

Страница: 30 / 140

30
after the measurement with the symbol . This can be an
indicator for arrhythmia. Arrhythmia is an illness in which the
heart rhythm is abnormal because of flaws in the bioelectrical
system that regulates the heartbeat. The symptoms (skipped
or premature heart beats, pulse being slow or too fast) can be
caused by factors such as heart disease, age, physical make-
up, excess stimulants, stress or lack of sleep. Arrhythmia can
only be determined through an examination by your doctor. If
the symbol appears frequently, please consult your doc-
tor. Only they are able to determine any arrythmia during an
examination.
Risk indicator
The measurements can be classified and evaluated in accord-
ance with the following table.
However, these standard values serve only as a general guide-
line, as the individual blood pressure varies in different people
and different age groups etc.
It is important to consult your doctor regularly for advice. Your
doctor will tell you your individual values for normal blood pres-
sure as well as the value above which your blood pressure is
classified as dangerous.
The bar chart on the display and the scale on the device show
which category the recorded blood pressure values fall into.
If the values of systole and diastole fall into two different cat-
egories (e.g. systole in the high normal category and diastole in
the normal category), the graphical classification on the device
always shows the higher category; for the example given this
would be high normal.
Blood pressure
value category
Systole
(in mmHg)
Diastole
(in mmHg)
Action
Level 3:
severe hy-
pertension
red ≥ 180 ≥ 110
Seek medical
attention
Level 2:
moderate
hyperten-
sion
orange 160 – 179 100 – 109 Seek medical
attention
Level 1:
mild hyper-
tension
yellow 140 – 159 90 – 99
Regular monitoring
by doctor
High nor-
mal
green 130 – 139 85 – 89
Regular monitoring
by doctor
Normal green 120 – 129 80 – 84 Self-monitoring
Optimal green < 120 < 80 Self-monitoring
Source:
Saving, accessing and deleting measured values
The results of every successful measurement are stored to-
gether with the date and time. If there are more than 60 meas-
urements, the oldest measurements are lost.
• To access memory recall mode, the blood pressure monitor
must first be started. To do this press the Start/stop button
.
• After the full-screen display, select the relevant user mem-
ory that you want to see the measurement data for within 3
seconds using the M1 or M2 memory button ( M1 for or
M2 for ).