OPERATING
BETTCHER
AIRSHIRZ
®
INSTRUCTIONS
INDUSTRIES, INC. Rev. September 24, 2016
Page 59
9.4.10
Finger Loop and Spring Installation (Continued)
FIGURE #54
•
First, place the Teflon washer onto the post. Then place the finger loop onto the post,
above the spring and rotate it fully counterclockwise until it is against the cover post (with
blade latch removed).
•
With the thumb of the left hand, pull upward on the spring until the spring tip is aligned
with the notch of the finger loop. Push downward on the finger loop while wiggling it
slightly until the spring engages the notch and the finger loop moves fully onto the post.
•
Install servo link assembly (see Section 9.4.7) and perform finger loop post screw
adjustment procedure (See Section 9.2.1).
•
Install blade latch ring (Section 9.4.4) and cover (Section 9.4.2).
9.4.11
Drive Link Removal
•
Disconnect the air line.
•
Remove blade set (Section 8.3.2), cover (Section 9.4.1) and blade latch (Section 9.4.3).
•
Remove the front tubing from the air fitting at the frame. (See Section 9.4.21).
•
Unscrew the air fitting using a 1/4 inch hex socket wrench.
Grease
Grease
Teflon®
Washer
