BETCO FOREMAN AS20B, Руководство оператора

Страница: 8 / 58

11
MACHINE PREPARATION
11. ADJUSTMENT SQUEEGEE INCLINATION
During working operation, the rear rubber has to work slightly tilted backwards and this equally in its
whole length for about 5mm. Should it be necessary to increase the rubber bending in the central
part, then tilt the squeegee body backwards and turn the adjuster (1) counterclockwise. If the rubber
bending is to be noticeable at the sides of the squeegee, turn the adjuster clockwise. At the end of the
adjustment, block the adjuster nut.
12. MANUAL BRUSHES ASSEMBLY
1.
Use lever (1) to lift the base (lever downwards).
2. Turn key (2) to OFF and remove it from the control panel.
ATTENTION! installing the brushes with power on may cause injury to the
hands
1.
With the base raised thread the brushes into the seat on the plate below the base, turning them
until the three buttons enter the holes on the plate. Turn them abruptly to push the button towards
the retaining spring so that the brush locks in place.
The photo shows the direction of rotation for installing the right brush. Rotate the opposite direction to
install the left brush.
For the single brush models the procedure is the same and the rotation direction for the brush
coupling is the opposite of what indicated on the picture.
• (Only for double brush machines)
We recommend inverting right and left brushes every day and vice versa. If brushes are not new and
have distorted bristles then it is best to install them always in the same position (the right brush on
the right side and the left brush on the left side) to prevent bristles with a different slope from
overloading the brush motor and causing excess vibrations.