BETCO FOREMAN AS20B, Руководство оператора

Страница: 10 / 58

13
PERFORMANCE
1. SETTING FOR WORK
1. Set the machine up for operation.
2. Check that the parking brake is released (1).
3. Connect the connector to the batteries (2).
4. Turn the main switch key (3) a quarter turn clockwise. The battey led display immediately comes
on.
5. Press brush switch (1).
6. Press aspiration switch (2).
7. Use knob (3) to adjust water flow.
8. Push the lever (1) to lower the base.
9. Pushing the lever, lower the squeegee assembly (2).
9.
(Only machines with traction motor)
The machine will start to move when deadman lever (1) is pushed forward. Check, during the first few
meters of wash, that brush pressure is adequate (see "BRUSH PRESSURE" below), that the amount
of water is sufficient and that the squeegee dries the floor
perfectly.
The machine will now start to work at full efficiency until the solution water is finished. Immediately
apply emergency brake (2) on the left side of the machine whenever problems arise during operation.
This control stops forward movement by the machine. To start to work again, after solving the
problem, just raise level (2) and push deadman lever (1) forward.