BETCO FOREMAN AS20B, Руководство оператора

Страница: 6 / 58

9
MACHINE PREPARATION
3. INSTALLATION OF THE BATTERIES INTO THE MACHINE
The batteries must be housed in the battery compartment below the recovery tank. They must be
handled using special hoisting equipment with suitable grasping systems and designed to support
the weight of the batteries. The batteries must also conform to the requirements given in CEI 21-5
standards.
ATTENTION! Comply scrupulously with the instructions given by the
manufacturer or his retailer for daily battery charging and maintenance. All
installation and maintenance procedures must be done by expert personnel.
Danger of inhalation of gases and leakage of corrosive fluids. Danger of fire:
do not approach with open flames.
4. CONNECTING THE DRIVE MOTOR CABLE
ATTENTION! This job must be done by a Fimap Service Center technician.
5. CONNECTING THE BATTERY CHARGER
The battery connector (1) must fit into the corresponding connector on the battery charger.
The battery charger connector is delivered inside the bag that contains this instruction booklet. It must
be fitted to the battery charger cables according to instructions.
ATTENTION! This operation must be completed from qualified staff. A wrong
or imperfect connection of cables to the connector can cause to serious
damages to persons or things.
1
2
6. RECHARGE OF THE BATTERIES
Batteries, to avoid permanent harm to them, should never be totally discharged. They should be
recharged within a few minutes after the battery discharged signal starts to flash.
ATTENTION! Never leave the batteries completely discharged, even if the
machine is not being used. When recharging the batteries, keep the recovery
tank lifted supporting it with the prop as indicated in figure. Make sure that the
battery charger is suitable for the used batteries capacity ant type.
ATTENTION! Danger of gas exhalations and emission of corrosive liquids
ATTENTION! Fire danger Do not approach with free flames