8
USE AND MAINTENANCE TIPS
1. REMOVAL OF BRUSHES AND CLEANING THE MACHINE
After each use, the brushes should be removed and cleaned. The underside of
the machine should be cleaned as well.
A. Disconnect the power supply from the machine.
B. Lay the machine on the floor and pull the axle out from the center of
the brush on the right side of the machine.
C. Clean the brushes with jet-powered water.
D. Clean the underside of the machine wih a hand brush or cloth.
E. To install the brushes, simply slide the axle back through the center
core of the brush until it locks into place on the left side of the machine.
F. The brushes should be replaced once the overall bristle-to-bristle
diameter is less than 2.75”.
2. MOTOR SAFETY SWITCH
A. The safety switch automatically cuts off the electricity when the motor
overloads.
B. Should this happen, disconnect the power supply, wait 30 seconds, and
press the button inwards to reset the safety switch.
C. Then reconnect the power supply and continue working.
3. TANDEM USE
Two machines can be connected together to double the productivity of
carpet cleaning.
A. Position two machines side-by-side facing in the same direction.
B. Completely remove the handles from both machines.
C. Install the tandem mounting bar on the handle posts for both
machines.
D. Install one of the operator handles to the tandem mounting bar.
E. Plug the short cord from one machine to the open electrical socket on
the rear of the second machine.
F. Connect the power cord from the second machine to the extension
cord.
G. Press the activation lever on both machines to lower the handle and
begin use.
WARNING: Carry out all maintenance operations with the
power cord unplugged from the wall outlet.
