6
7.
FASTDRAW
®
System Installation
Step 1: Mounting the Proportioner to the Wall
1. Find the appropriate hole pattern for your installation.
NOTE:
If the dispenser is being hung with the internal
hole patterns, you must remove the cover. To remove the
dispenser cover, first remove the screw on the front lever
with a Phillips screwdriver.
Then press down on the upper, snap-in tab and rotate the
cover forward.
To replace the cover, first insert the two lower tabs into the
slots and rotate the cover until the housing snaps into place.
2. Mark appropriate holes for drilling. Use the 1/4” diameter
bit with the included #10 x 3/4” long screw and anchor set.
If your are mounting the dispenser to wood and do not plan
to use anchors, drill 1/8” diameter holes.
3. Insert the anchors into the drilled holes and hammer them
into the wall until they are flush with the wall. Insert the
threaded screws into the anchors so the screw heads are
sticking out approximately 3/8”. Position the dispenser holes
over the screw heads and slide down until the keyhole slots
are resting on the screws. Use a level to make sure the
dispenser is hung properly. Tighten the screws.
