BETAFPV LiteRadio 2 SE, Быстрый старт

Страница: 4 / 16

03
4.Binding the Receiver
There are the steps to make the LiteRadio 2 SE enter binding status.
1. Power on the remote control radio transmitter and wait for its system to load
completely. LED ring is solid blue.
2. Press the bind button on the back of the transmitter to enter binding stutas. The
LED ring will be red and ash quickly.
3. The LED ring will change to solid blue 5 seconds later when transmitter exits
binding status. If not bind successfully, repeat the process above.
5.Switching Protocol
Note: switching protocol is only available for Frsky version radio transmitter.
ExpressLRS version or Bayang version are not suppo ed.
The Frsky version could suppo 4 di erent protocols, including Frsky D16 FCC,
Frsky D16 LBT, Frsky D8 and Futaba S-FHSS. The protocol is indicated by the
ashing times of the red LED when power on, before the buzzer alarms.
LED Status
Protocol Version
Flash once
Flash twice
Flash Three Times
Flash Four Times
Frsky D16 FCC (ACCST 1.X Version)
Frsky D16 LBT (ACCST 1.X Version)
Frsky D8
Futaba S-FHSS
1. Power the radio transmitter o ;
To change protocols (Frsky FCC D16, Frsky D16 LBT, Frsky D8, or Futaba S-FHSS),
here are the steps:
2. Press and hold the BIND button while power the radio transmitter back on;