Beta EVO 4T 2012, Руководство пользователя

Страница: 22 / 38

betamotor.com
3
ENGLISH
Maintenance and checks
62
A
B
CLUTCH MASTER CYLINDER FLUID
Check the fluid in the reservoir. The level
must never be below half-way up the reser-
voir. To bring the clutch fluid up to the cor-
rect level, refill the reservoir by unscrewing
the two screws A, removing the filler cap B
and topping up the fluid.
Note
Change the fluids in accordance with the inter-
vals in the table on page 71, using the lubricants
recommended on page 53.
BLEEDING THE CLUTCH SYSTEM
To bleed the air from the clutch system, fol-
low the steps below:
- Remove the rubber cap from the bleed-
nipple C.
- Take off the clutch fluid reservoir cover.
- Fit one end of a small transparent tube
over the bleed-nipple D, and insert the
other end into a container.
- Pump 2/3 times with the lever and hold
the lever down.
- Unscrew the bleed-nipple, allowing the
fluid to flow through the tube.
- Reclose the bleed-nipple and release the
lever.
- If you can see air bubbles through the
tube, repeat the above operations until
the fluid that comes out is free of air.
Note
During this operation it is important that you top
up the master-cylinder reservoir continually, to
compensate for the fluid which has been pum-
ped out.
- Remove the small tube.
- Refit the rubber cap.
Note
Handle brake fluid with care: since it is corrosive,
it can cause irreparable damage to painted or
plastic parts
C
D