Bestway
®
Pool Installation
5
Assembly should be carried out by a minimum of 2 people and usually takes approximately 1 hour.
Tool required:
A crosshead screwdriver (not included), an inner hexagon wrench (included), and a big plastic wrench (included).
In order to facilitate the pool installation, please set up the safety ladder to easily enter and exit the pool.
Ground Preparation
1. Select a solid, level location and clear it with any sharp objects or debris.
2. Take all accessories out of the carton with care. Remove the ground cloth and spread over the ground cleaned. Then spread out the pool liner on the center of the
ground cloth. Let them sit exposed to direct sunlight for moment so they will be more flexible during set up.
Wall Panel Installation
There are two types of wall panels that need special attention during set up:
First, three wall panel which needs to be installed with the inlet & outlet holes and
second, the warning panels which needs to be installed in a location that the warning display is easily seen by pool users before entering the pool. These two special
panels should be distributed as in Fig.1.
1. Start by installing Wall Panel C, this is where your filter will also be installed so make sure your power supply is in reach. Place two Supports (1) on the ground
cloth, ensure the grooves face the center of the pool. Slide Wall Panel C (5) onto the Supports and make sure the groove faces upwards and the ridge faces
downwards. You might need to use force to press the wall panel so it touches the ground. Add another wall panel so you have two in position.
2. Place another Support into position to the left of Wall Panel C and add two more Wall Panels. (See Fig.2)
NOTE:
It is important to install the wall panels so they touch the ground.
3. With two Wall Panels on one Support add a link to the Support. (See Fig.3)
NOTE:
These Links offer superior support and will be added on top of each set of two Wall Panels.
4. Continue installing the first two layers of wall panels all around the pool adding Links after each set of two Wall Panels. (See Fig.4)
NOTE:
The ridges on the Wall Panels must to be fully inserted into the grooves of the Wall Panels.
5. Make sure the circular form of the pool is correct.
6. Install the rest of the Wall Panels and Links. The Wall Panel B, Wall Panel A and Warning Panel should be installed in place as Fig.1. When finished, it will be eight
pieces of Wall Panels and four Links for each section of wall. (See Fig.1 and Fig.5)
Inner and Outer Vertical Panel Installation
Install the Inner Vertical Panels (11) and Outer Vertical Panels (12) into the grooves at the base of the Supports (1). Insert and screw the M6 bolts (13) from the
outside. (See Fig.6)
Pool Liner Installation
1. Place the safety ladder inside the pool and to allow on person to enter and spread out the pool liner. The second person will provide support outside of the pool.
2. Make sure the Outlet, Inlet holes and the Drain valve on the Pool Liner match the holes on Wall Panel A, B and C. Insert the Drain valve into the hole of Wall Panel
C and cover the Drain Valve Cap from outside of the pool wall.
3. Working around the pool, place the Liner into position over the Supports. (See Fig.7)
Top Rail and Junction Cap Installation
1. Put two Top Rails (16) on the top of a Support. Make sure the pool liner is smooth under the Top Rails. Add a Junction Cap (17) and two M10 Bolts (18), screw
them into position. (See Fig.8)
2. Repeat this procedure to install all the Top Rails and the Junctions. With all Junctions in position, use the Bolt Caps (19) to protect the M10 Bolts.
Fig.1
Fig.2
Fig.3
Fig.4
Fig.5
Fig.6
Fig.7
Fig.8
Pool Liner
S-S-000856
S-S-000856/21.0x28.5cm(#56191/C
版
) JS-YF-2009-B-01270/
英
