Rev. B 0912
53819 pg. 4
Halftop – Installation Instructions
Orient the Left and Right Door Surround
Assemblies on the vehicle with the brackets toward
the inside and the hook strip toward the outside.
Insert the nipples in the brackets into the holes in
the bottom of the Horizontal Support Bar. Thread
a Knob from the parts kit through the top of the
Horizontal Support Bar and into each of the Door
Surround Brackets. Close the door to check the
seal and adjust the Front Door Surround Bracket if
necessary for a good seal.
Windshield Header Installation
Orient the Windshield Header on the vehicle and
lay it on top of the windshield frame. Catch the hook
on the header in the slot in the windshield frame
and close the lever over it. This will hold the header
securely in position.
Windshield
Frame
Windshield
Header
Latch
Close lever over
top of hook
Catch hook
in slot
Knob
Detail of Knobs
Door Surround
Bracket - Front
or Rear
Horizontal
Support Bar
Thread Knob
into Bracket
Front Door Surround
Bracket
Horizontal
Support Bar
Door Surround
Front Door Surround
Bracket from Bottom
Hook
Strip
Install Door Surround
Assemblies
Driver's Side Shown
Door
Surround
5/16" Washer
5/16-18 Tapping
Plate - under ledge
5/16-18 x 1 Phillips
Head Bolt
Secure the bottom of the Door Surround
to the vehicle using a 5/16-18 x 1 Phillips
Head Bolt, a 5/16" Washer and a 5/16-18
Tapping Plate. Place the Tapping Plate
under the ledge, aligning the hole in the
plate with the hole in the vehicle and install
the screw and washer from the top. Test the
door seal again and adjust the bottom of the
Door Surround if necessary for a good seal.
Install Door Surround Assemblies