Installation Instructions for Wi-Q Technology™ EXQ Exit Hardware Trim
BEST
a Product Group of dormakaba USA Inc.
16
Installing the exit hardware and trim
14
Install core
1 Insert the control key into the core and rotate the key
15 degrees to the right.
2 With the control key in the core, insert the core into
the cylinder as shown in Figure 27.
3 Rotate the control key 15 degrees to the left and with-
draw the key.
Caution:
The control key can be used to remove
cores and to access doors. Provide adequate secu-
rity for the control key.
15
Install mortise case faceplate
(mortise exit devices only)
1 Secure the mortise case faceplate to the mortise case;
follow the instructions provided by the exit hardware
manufacturer.
2 Check the lock for proper operation.
16
Install strike(s)
Note:
If retrofitting the trim to an existing exit hardware
installation, skip this task.
1 Install the strike(s) in the door frame or door stop; fol-
low the instructions provided by the exit hardware
manufacturer.
2 Check the lock for proper alignment between the
strike(s) and latch(es).
Figure 27 Installing the core
Control key
Core
Outside of door
Cylinder
