DKAC-I / MBAC-I
- Climate gateway
Programming manual
v1.0
www.besknx.com
10
Description
This parameter allows the use of the air conditioning gateway in master or slave mode, in case this last
mode is supported.
Parameter
Swing
Value
Yes / No
Description
This parameter allows to enable the control options on the slats of the climate machine. A tab will appear
in the left part of the window for that purpose.
Parameter
Configuration after voltaje recovery
Value
Yes / No
Description
This parameter allows to enable the options that allow the selection of the modes in the start of the
gateway after recovering tension. A tab will appear in the left part of the window for that purpose.
Parameter
Set point temperature limits
Value
Enable / Disable
Description
If the measured temperature transmission parameter is set as cyclically or both, this additional
parameter allows defining the period for sending notifications in seconds.
Parameter
Temperature measured feedback
Value
Yes / No
Description
Allows the enabling of notifications to the KNX bus or the reading of the temperature measured by the
climate machine. By enabling this option, the time interval between notifications will be available for
selection.
Parameter
Window opening protection
Value
Yes / No
Description
Enables the activation of the window opening protection that allows an energy saving of the installation.
Parameter
Scenes
Value
Yes / No
Description
This parameter allows you to configure or record scenes on the device. A new tab will be enabled in the
left part of the window for that purpose.
Parameter
Error handling
Value
Yes / No
Description
This parameter allows to enable the communication objects by which the gateway notify the internal
and/or external errors of the machine.
Parameter
Advanced functions
Value
Yes / No
Description
With this parameter the logical unit and timers of the gateway are enabled.
3.4.2
Modes
In the configuration tab of the operating modes, the following options are available:
