Berthoud VERMOREL 3000 ELECTRIC, Инструкция по эксплуатации, Страница: 16 / 68

ENGLISH
11 - MALFUNCTIONS / SOLUTIONS
MALFUNCTIONS OBSERVED POINTS TO CHECK ACTION NEEDED
Leak between the handle and
the lance tube.
Seal is present and in good
condition.
Put it back in place or replace.
Once the machine is stopped,
the lance continues to flow.
Air is blocked inside the
telescopic lance.
Fully unfold the telescopic
lance.
Spray for 10 seconds with the
lance unfolded and point it
up to expel the air blocked in
the lance.
The battery does not seem to
charge.
a) Check that the charger is
working properly (indicators).
b) The battery is old.
c) The battery is relatively new.
a) Replace if it is not
working.
b) Replace the battery.
c) Contact the Customer
Service.
The battery does not seem to
have its normal lifespan.
a) The battery is old.
b) The battery is relatively new.
a) Replace the battery.
b) Contact the Customer
Service.
The motor runs, but the machine
sprays weakly
Cleanliness of the suction filter
on the base of the tank.
Clean the filter.
The motor runs, but the machine
does not spray.
a) The nozzle is clogged.
b) The nozzle is clean.
a) Clean the nozzle.
b) Do not attempt to repair.
Contact the Customer Service.
The motor does not run. a) The battery is not connected
b) The red battery charge
indicator flashes.
c) The red battery charge
indicator lit up and does not
flash.
a) Connect the battery to your
Vermorel
b) Recharge your battery
c) Contact the Berthoud
Customer Service.
Poor spraying a) Check the recommended
positions for each nozzle.
b) Nozzle calibration not
optimised.
c) Presence of air in the lance.
a) Use the recommended
positions for each nozzle.
b) Stop and restart your
sprayer.
c) Refer to Section 4.3
Leakage of water at the base of
the machine.
Check the connections and
condition of the pump and
priming feed tubes.
Tighten if necessary.
Replace if pierced.
If necessary, contact the
Customer Service.