Berthoud RAPTOR 2540, Руководство пользователя

Страница: 43 / 54

43
82.490 - Raptor
7.4. LAST FILLING OPERATION
• When filling the tank for the last time, add only the amount of water and chemical necessary to spray the
remaining area.
7.5. MAINTENANCE AFTER OPERATION
• Fully rinse the sprayer internally (including tanks, booms and nozzles) in accordance with the procedures
given on pages 30 to 33.
•
Wash the outside of the sprayer as explained on page 40.
• Check the cleanliness of the nozzles and filter (see hereafter) .
•
Place into storage.
7.6. WINTER STORAGE OPERATION
• The sprayer should be wintered in a clean condition
(see above)
.
•
Rinse the circuit completely (with a cleaning product).
• Drain the tank.
•
Rinse with clear water.
•
Completely drain the liquid circuit, making sure that the pump is not used too long without water (2 minutes
maximum).
•
Protect against the frost, using sufficient antifreeze into the tank (glycol or coolant).
•
Start the pump slowly.
•
Operate all the valves so as to protect the pump, valves, regulation, filters and pipes.
•
Open the spray circuit to supply the boom with antifreeze. When the antifreeze reaches the nozzles, stop
spraying and stop the pump's hydraulic drive.
•
Grease all mechanical parts that can be rust.
•
Deoxidize the contacts on the power plugs (KF F2 aerosol BERTHOUD reference 765.065).
•
Clean the outside of the sprayer. Paint the mechanical parts exposed (blue paint aerosol, BERTHOUD reference
769.077 or green paint aerosol, BERTHOUD reference 778.890).
•
Garage the sprayer out of the sunlight and protected against inclement weather and on flat, load-bearing ground.
7.7. NOZZLES OR FILTER DIRTY
•
Clean and rinse dirty filter or nozzles using a brush and water.
- To do this, use the brush-wrench, BERTHOUD reference 779.354.
Never blow into a nozzle.