Berthoud RAPTOR 2540, Руководство пользователя

Страница: 32 / 54

32
82.490 - Raptor
PHASE 2 - RINSING THE SPRAYING AND BOOM CIRCUITS WITH THE RINSING TANK
(With the rest of the water in the rinsing tank)
OPERATIONS PERFORMED IN THE FIELD
With the pump off.
• Put the indexes on Berlogic function
(DUALELEC option, choose function
08-
).
- Open the spraying:
With the
C-TRONIC
control box (figure 7, page 28):
▪ Press the key next to the icon.
With the
-PILOT
mutifunction joystick (figure 9,
page 29):
▪ Press the key (6) of the
-PILOT
joystick.
- Engage the pump's hydraulic drive by pressing
push-button (3) (figure 8, page 29).
- Bring the engine speed up to at least 1,200 rpm by
raising switch (4) (figure 8, page 29).
- Spray the diluted product on the crops.
Note:
This operation is performed without water
returning to the main tank.
- Then, to close the spraying:
With the C-TRONIC control box
(figure 7, page 28):
▪ Press the key next to the icon.
With the -PILOT mutifunction joystick
(figure 9, page 29):
▪ Press the key (6) of the
-PILOT
joystick.
- Lower the switch (4) (figure 8, page 29) to reduce the engine speed.
- Press the push-button (3) (figure 8, page 29) to stop the pump drive.
This operation is not enough when changing chemical products.
PHASE 3 - RINSING ALL CIRCUITS WITH THE MAIN TANK
IN A RECOVERY AREA AT THE FARM
• Put 300 liters of clear water with a cleaning product (All Clear type) in the main tank (see filling page 25).
•
To mix the mixture, sections closed, put the indexes on Berlogic function .
(DUALELEC option, choose function
05-
) .
- Engage the pump's hydraulic drive by pressing push-button (3) (figure 8, page 29).
- Bring the engine speed up to at least 1,200 rpm by raising switch (4) (figure 8, page 29).
• Place the index (1) (figure 11, page 30) to position to begin the mixing.
(DUALELEC option , perform 2 short pressings of the key on the
C-TRONIC
control box to activate the
manual mixing, then adjust it on 100 % (see manual No. 82.510) .
• To rinse the hopper, put the indexes on Berlogic function .
(DUALELEC option, choose function
02-
) .
- Open the fill valve (4) to position (figure 5, page 27) to rinse, then drain the hopper.