CDP Installation Manual
21
c.
Disconnect each linkage arm as shown in Figure 28
Figure 28 - Disconnecting Linkage Arm
d.
On one dolly, make slight adjustments to the height of the lifting shaft until there is just
a small amount of weight on the dolly casters.
i.
The lifting shaft will move fairly close to the bottom end of the weldment
window, make absolutely sure that it does not hit that end point (see Figure 26).
e.
Lift the locking gate and pull back on the dolly to disengage it from the side rail as shown
in Figure 29
i.
You may need to make further adjustments to the height of the lifting shaft at
this step.
ii.
When disengaging the dolly, DO NOT pull on the very top of the dolly as this
introduces a large moment on the lifting shaft guide and that should be avoided.
iii.
Be careful at this step not to lose control of the dolly as it comes off of the side
rail as it can tip into the CDP base and scratch the powdercoat
Figure 29
f.
Remove the second dolly in the same way
