Bernini Be42, Руководство пользователя, Страница: 14 / 28

Be42 OEM's Manual V5.0.XX - December - 2010 page 14
14
Table 7.03A - ENGINE PARAMETERS
Note: [ xx " ] = seconds, [ xx ' ] = minutes, [ oFF ] = disabled
Parameter Code & Description Default Min Max Options
P.19 Crank delay (it delays the cranking) [ 2" ] 0 15secs -
P.20 Crank time (maximum cranking time if the
engine fails to start during the attempt)
[ 5" ] 1 sec 15secs -
P.21 Rest time (pause of time between starting
attempts)
[ 5" ] 3secs 15secs -
P.22 Pre-glow time
(see „Modes‟ for the mode of
operation
[ oFF ] 1sec 59mins [ oFF ]
Modes (see the figure below) [ 1 ] - - 1-2-3-4
Starting Motor Total rest timing
Pre-glow mode 1
Pre-glow mode 2
Pre-glow mode 3
[ P.21 ]
[ P.20 ]
[ P.22 ]
[ P.22 ]
[ P.26]..27]..28 ]
[ P.22 ]
Pre-glow mode 4 (Choke)
Total rest timing
Crank termination (engine running detect)
P.23 Engine Warm up time [ 15" ] 0 59mins -
P.24 Engine Cooling time [ 15" ] 0 59mins -
P.25 Stop Solenoid timing (Energized to stop) [ 15" ] 1sec 59mins -
P.26 Crank termination setting (Charger Alternator) [ 8.0 ] 3.0V 30.0V [oFF]
Belt break setting (Charger Alternator) [ 8.0 ] 3.0V 30.0V [oFF]
P.27 Crank termination setting (Generator Voltage) [ 70 ] 60V 998V [oFF]
P.28 Crank termination (GeneratorFrequency) [25.0] 20.0Hz 70.0Hz [oFF]
Table 7.03B - ENGINE PARAMETERS
Note: [ xx " ] = seconds, [ xx ' ] = minutes, [ oFF ] = disabled
Parameter Code & Description Default Min Max Options
P.29 Low Oil pressure warning [oFF] 0.1Bar 20.0 Bar [oFF]
P.30 High engine temperature warning [oFF] 40°C 250°C [oFF]
P.31 Crank attempts (numbers) [ 3 ] 3 15 -
P.32 Purge timing (for Gas fuelled engine) [ 1" ] 1sec 15secs -