Page 13 of 18
26.08.2014
Ver. 1.5
Copyright Berner Kochsysteme 2014
Please note for the build-in of a BERNER Steak Grill following points:
Observe the installation regulations
Under the unit a ground metal (CNS angles) has to be attached, the safety thermostat has to
installed accessible.
The ground metal must be absolutely removable so that in case of a
service the easy access to the unit is possible. Should this not possible, in case of special
construction caused other mounting variants, must be checked other Solutions. We are ready
to support you in case of other Solutions.
The switch faceplate is not included with the delivery (optionally available).
To ensure proper function, the instructions must be strictly observed.
The frame of the unit must be sealed down (Silicone Pactan 6076), to prevent ingress of
liquids.
Penetration of liquids will cause damage.
The following points have to be follow:
Installation requirements
-
The installation must be checked on practice suitability.
-
The electrical installations must comply with the local building installations regulations. The
valid national regulations of the electricity authorities must be followed.
-
In case of using an Offset current circuit breaker on the place, use a (FI 30mA).
-
Avoid that hot surrounding air is drawn in the unit by around standing equipment like deep
fryers etc.
-
Install the unit not in the proximity's of a hot surfaces
-
The using staff must take sure, that all Installations- , Maintenance - and Inspection work,
are executed by authorized specialist staff.
-
The units are equipped with an installation box (technical drawing). This box must be in
the case of service available for example the substructure.
-
Provide a possible disconnecting of the unit from the main power supply.
