Berner BTD-ETO100, Инструкция по установке, эксплуатации и обслуживанию

Страница: 38 / 41

S
ERIES
DECO-TUBE
38 A
PRIL
/25/2013
Maintenance & Trouble Shooting
Trouble shooting continued…
Burner Does Not Light

Is spark visible through site glass during ignition trial? If no, further electrical checks by a
qualified service person are required.

Check to see if gas lines were properly purged of air.

Check inlet and outlet gas pressure during ignition period.

Check for proper orifice and air plate.
Burner Does Not Stay Lit

Check ground wire continuity.

Check insulation on the igniter leads.

Measure flame signal current; it should be between 2 to 6 micro amps dc. Minimum 0.8
micro amps.

Clean flame rod if necessary.

Replace module if necessary.