(EN)
After checking the grinding wheels (see safety instructions) reassemble the grinding wheels, but use soft shim (e.g.
paper) between grinding wheel and shaft.
In a matter of transportation the grinding bases and guards are not assembled to the machine. Connect them with
the delivered screws as shown in picture 1.
Adjust the grinding bases in accordance with the grinding wheels. Too wide spacings between grinding base and
wheel may cause serious accidents. The spacing may therefore amount to 3 mm maximum.
When the machine is connected to the local mains care must be taken that the voltage correspondent to the rating
shown on the performance plate.
The machine may now be taken in operation by switching on the switch (1)
5.0 Declaration of Conformity
We declare that the machine as described on
the front page come up to all general health-
and safety rules. CEE-regulations.
2006/42/EG (machlne standards)
2006/95/EG (low voltage standards)
2004/108/EG (EMV·standards)
applicable harmonized:
DIN EN ISO 12100:2011·03
DIN EN 60204·1/A1
Künzelsau, 26. März 2018
i. V. Bert Habets
Senior Director Continuous Improvements
produced for
Berner Trading Holding GmbH ·
Bernerstraße 6 · D-74653 Künzelsau · GERMANY · www.berner.eu
