Berner 175035, Оригинальное руководство пользователя

Страница: 21 / 197

English - 6
This machine is also intended to be powered by
a.c. generators with sufficient power output that
correspond with ISO 8528, design class G2.
Compliance with this Standard in particular is
not given when the so-called distortion factor
exceeds 10%. When in doubt, inform yourself
about the generator in use.
Operating Instruction.
Mounting the auxiliary handle (Figure 6).
➤
Screw the auxiliary handle tightly onto
the left or right side of the power tool,
depending on the working method. For this,
remove the respective screw of the gear housing
cover.
Mounting the gear housing cover (Figure 5).
➤
Attach the gear housing cover onto the
gear head and tighten with the two screws.
Changing the tool.
Attaching or changing the polishing accessory.
Only press the locking button (1) when
the motor is not running.
➤
Press the locking button (1) and keep it
pressed down.
➤ Change the used polishing accessory or
insert a new one.
➤
Press the locking button (1) and keep it
pressed down. Screw the polishing acces-
sory tight.
Securing the work piece.
➤ Secure the workpiece adequately.
A work-
piece that is not properly secured can, for
example, cause the polishing accessory to jam and
kick back, fall and cause other hazards.
General operating instructions.
Switching on and off (Figure 2)
Switching on:
Push the switch toward the front (I).
Switching off:
Press the switch downward (0).
Setting the speed (Figure 3)
Set the dial control between „1“ for the lowest
speed and „6“ for the highest speed.
Conduct the mains lead away from the rotat-
ing polishing accessory.
If you lose control
over the power tool, the mains lead could be cut
through or caught, thereby drawing your hand
or your arm into the rotating polishing acces-
sory.
Polishing
Press the power tool on evenly and move
it over the surface.
Do not strain the power tool!
Do not allow the surface of the workpiece
to become too hot.
Repair and customer service.
Blow out the interior of the power
tool at regular intervals from outside
through the air vents with dry, compressed air.
If the supply cord of this power tool is damaged
it must be replaced by a specially prepared cord
available through the Berner customer service
centre.
If required, you can change the following parts
yourself:
Application tools, auxiliary handle, safety guard,
work arbors, flanges.
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an authorized after-
sales service centre for Berner power tools.
In all correspondence and spare parts orders,
please always include the 6 digit order number
given on the nameplate of the machine.
Accessories.
Only use accessories recommended by
Berner.
Selection of accessories (Fig. 8).
Use only original Berner accessories. The acces-
sories must be intended for the power tool type.
Use accessories A–L with the safety guard moun-
ted.
A Backing pad for lambskin with tensioning
cord
B Backing pad with Velcro, Velcro sanding
sheets, sanding fleece with Velcro, sponges,
lambskin
C Cup brush
D Steel wire brush, round
E Backing
pad
F Extraction hood
G Nettle buffer / Flannel buffer
H Flap
wheel
I Polishing wheel (felt)
J Sanding fleece, polishing rings
3 41 01 188 06 0.book Seite 6 Mittwoch, 5. Dezember 2012 9:48 09