picture 7: Detection planes
o
Select a vibration-free installation location. Vibrations can lead to unwanted switching.
o
Avoid interference sources in the detection area. Interference sources, e.g. heaters,
ventilation, air conditioners, and cooling light bulbs can lead to unwanted switching.
i
If necessary, the detection area can be limited using the push-on top (see Limiting the
detection area).
Installing the motion detector cover
The concealed insert is connected and installed correctly (see Concealed insert instructions).
i
Use a surface-mounted housing for surface installation.
i
Use a wind-tight connector socket for cavity wall mounting.
o
Attach the motion detector cover and frame to the concealed insert.
Expanding the detection area
To expand the detection area, connect a 3-wire extension insert with motion detector cover (see
instructions for 3-wire extension insert).
The motion detector of the main unit also evaluated recorded motions of the extension and, if
necessary, switches the lighting on.
o
Using the adjuster (7), adjust the sensitivity to the ambient conditions.
o
Attach the motion detector cover and frame to the extension concealed insert.
i
Only the sensitivity of motion detectors on extensions can be set individually. The adjuster
for run-on time, brightness threshold and the operating mode switch do not have a function.
i
Do not connect any main units in parallel.
i
When operating an extension with motion detector tops, it should be noted that, after
switching the lighting off, a locking time of approx. 3 seconds must elapse, before the
lighting can be switched on using the extension.
Seite 7/10
22.07.2010
82540231
97-82640-201
BLC
BLC motion detector comfort 1.1 m
