REMOVAL AND REPLACEMENT OF PARTS
SHARPENER
Sharpener Removal
Disconnect the electrical power to
the machine and follow lockout /
tagout procedures.
1.
Press down on lower tab.
Fig. 1
2.
Remove sharpener.
3.
Reverse procedure to install.
4.
Check slicer for proper operation.
Sharpener Disassembly
NOTE:
Remove only those parts required to access
part(s) being replaced.
Fig. 2
1.
Remove deburring assembly.
A.
Remove nut (15) and washer (14).
NOTE:
Parts (15), (17), (11), and (21) are left hand
threaded on some older sharpeners.
B.
Remove deburring stone (13) and skirt (12).
C.
Remove e-clip (10), slide out shaft (5) while
holding spring (16).
D.
Remove spring (16) and deburring frame (9)
assembly.
1)
Remove e-clip (6).
2)
Remove bushing (7).
3)
Remove spring (8, in compression).
2.
Remove sharpening assembly.
A.
Remove nut (17) and washer (18).
B.
Remove sharpening stone (19) and skirt
(20).
C.
Remove e-clip (1).
D.
Remove washer (2), fiber washer (24),
bushing (23), spring (22, in compression),
and shaft (21).
3.
Reassemble sharpener in reverse order.
X13 SLICER - REMOVAL AND REPLACEMENT OF PARTS
Page 7 of 36
F25332 Rev. A (0718)
