7.
Remove motor, bracket, and wires from top
housing.
NOTE:
During motor installation, be sure to align drive
belt correctly. The motor drive shaft should be inside
the drive belt; the belt tensioner should be on the
outside of the belt.
Fig. 5
8.
Install motor, brackets, and wires in reverse order
of removal.
CONTROL BOARD
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
1.
Remove base housing as outlined under BASE
AND TOP HOUSING.
2.
Tag and marks all wires and connectors.
3.
Remove wire ties as necessary.
4.
Remove 12 connectors from control board.
Fig. 6
5.
Remove five Torx screws and control board from
control board plate.
Fig. 7
6.
Install control board in reverse order of removal.
KNIFE SHAFT
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
1.
Remove base housing as outlined under BASE
AND TOP HOUSING.
2.
Remove motor as outlined under MOTOR.
3.
Remove control board as outlined under
CONTROL BOARD.
4.
Remove wires and wire ties from control board
plate.
5.
Remove Torx screws and control board plate
from top housing.
Food Processer - REMOVAL AND REPLACEMENT OF PARTS
Page 5 of 13
F25264 (0116)
