REMOVAL AND REPLACEMENT OF PARTS
BASE AND TOP HOUSING
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
1.
Remove cutter/mixer bowl or feeder attachment.
2.
Position unit on blocks as shown to protect knife
shaft from damage during disassembly.
3.
Remove four screws and base housing from top
housing.
Fig. 1
4.
Install in reverse order of removal.
MOTOR
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
1.
Remove base housing as outlined under BASE
AND TOP HOUSING.
2.
Tag and mark all wires.
3.
Remove foam spacer from motor.
4.
Remove four wire connectors from control board.
Fig. 2
5.
Remove screws from motor mounting bracket
and lift motor from housing.
Fig. 3
6.
Carefully turn motor and bracket over to remove
the Torx screw and sensor.
Fig. 4
Food Processer - REMOVAL AND REPLACEMENT OF PARTS
F25264 (0116)
Page 4 of 13
