Bergstrom NITE Phoenix, Руководство по установке

Страница: 23 / 67

2-2
Electrical Installation
3
5
4
Attaching Hold-down Brackets
Set two batteries side-by-side in the
battery box and place a hold-down
bracket on top, with the u-channel
facing up. Take two 5/16″ bolts, place
a 5/16″ flat washer on each, and then
put the bolts through the outer holes.
Tighten each bolt securely from under-
neath using the supplied nuts and
washers. Repeat the procedure for the
other two batteries.
Preparing Cables
The batteries are wired series/parallel
for 6 volt or parallel only for 12 volt.
See diagrams on pages 2-3 and 2-4
Make and Install All Cables described
in steps 6a or 6b depending on which
batteries you are using.
NOTE: Before performing any wiring, Disconnect Truck Batteries.