Bergstrom NITE Phoenix T2000, Руководство по установке

Страница: 28 / 72

28
2-4
Directions for Wiring a 6-Volt Series/Parallel, 4 Battery NITE Phoenix
Step 1: Make and install the two short battery cables. These cables
connect the positive (+) of one battery to the negative (-) of the other to
create a set or bank. We refer to this as a series connection.
See
drawing below. DO
N’T connect any other cables or wires to these
terminals .
Step 2: For the positive to positive parallel connections, measure and cut
a piece of red cable to the proper length. Attach a ring terminal to each
end using a professional grade crimper. Place heat shrink around each
terminal and heat. Then loom it. Use this cable to connect the positive (+)
of one bank of batteries to the positive (+) of the other bank of batteries.
Step 3: Repeat Procedure for the negative to negative connection using
black cable. Then loom it. Use this black cable to connect the negative (-)
of one bank of batteries to the negative (-) of the other bank of batteries.
Do NOT use truck frame as a ground
Battery Set Battery Set
Connect positives
here: AC unit, Heater
and separator
Connect negatives
here: AC Unit,
heater, and Truck
Battery negative
BMS =Battery Management System
Electrical Installation Electrical Installation
=12V
5a