Bergstrom NITE Phoenix T2000, Руководство по установке

Страница: 13 / 72

13
1-11
Installation Procedures
Cut Hole in Truck Floor
Drill starter holes in all four corners of the
area marked for cutting.
Note location of
cross members prior to drilling holes. Use
air saw/jigsaw to cut through the truck floor.
Using a vacuum will help control dust.
Position the NITE Phoenix Mounting
Template
, as shown, with the condenser
opening over the hole cut in the truck floor.
Mark 4 mounting feet locations as indicated
in photo. The unit has 8 possible locations
but you will only use 4. Use equal spacing
to provide adequate stability of the Phoenix
unit. Predrilling holes for the mounting
screws will aid in keeping the unit square
with the condenser openings.
Optional Heater
Use the heater mounting plate as a guide,
check for clearance around heater. Mark
center of the plate. Using a 4″ hole saw cut
the opening in the floor. Place silicone
sealant around heater weldment and install
it from under the truck to the floor. Must be
positioned correctly to allow exhaust and
intake hoses to pass through each side of
the weldment. Make sure this area is
sealed to protect the floor.
NOTE: Silicone sealant is not
included in kit.
5
6
7