Mic-Fi User’s Manual
page 14
7.4
Measurement on Windows Systems
Line measurement
Allows you to measure the linear distance between two points. Simply
click and drag to the desired length, and click again to finish.
Point to Line Measurement
Allows measurement of a line 90 degree from a certain line. Simply
create a line to represent the base by clicking once to start, drag, and
then click again to set the endpoint. Branch off from the base line to
start measuring the line that is 90 degree from the base line and a final
click to finish the measurement.
Continuous Line Measurement
Allows measurement of the distance between multiple connecting
lines. Simply click and drag to form one section of distance, click again
to start another section. Continue until the total desired distance is
measured. Double-click to finish.
Polygon Measurement
Allows measurement of a polygon. Simply click and drag to form the
desired length, and click again to start the next section, double-click to
finish the polygon measurement.
Radius of Circle Measurement
Allows you to measure the circumference, area, and radius of a circle.
Simply click and extend out to the desired radius.
Diameter of Circle Measurement
Allows you to measure the circumference, area, and radius of a circle.
Simply click and extend out to the desired diameter.
Three Point Circle Measurement
Allows the measurement of the circumference, area, and radius of a
circle. Simply click on any three points on the circle you wish to
measure.
Three Point Arc Measurement
Allows a measurement of an arc. Click on three consecutive points on
an arc to measure.
Three Point Angle Measurement
Allows the measurement of an angle. Start at the pivot point and
extend out to start measuring an angle.
Four Points Angle Measurement
Allows the measurement of an angle by selecting four points. Simply
select two points from one line segment and another two points from
another line segment to complete the angle measurement.
To measure, please enter the magnification if there is not number.
The number is the scale value on the roller when capturing the photo.
