Bergen Intrepid Magnum Tazer, Руководство пользователя, Страница: 76 / 88

Install the tail hub onto the tail output shaft with ONE, and only ONE
3X4 setscrew and loctite. The tip of the setscrew MUST sit into the
divot on the output shaft. Only one setscrew IS more secure than 2
setscrews 180 degrees apart in this application.
The aluminum tail blade grips already have the radial bearings
installed, so begin by inserting the 4X4 stainless shoulder bolt in the
eyelet. A drop of oil here is also a good idea.
Place a small drop of loctite on the threads of the shoulder bolt and
screw into the horn on the tail blade grip, being VERY careful NOT to
get loctite into the joint. This will make the joint stiff and your tail
rotor system will NOT function properly, causing servos to overheat,
tail wags, sticking, etc.