Bergen Intrepid Magnum Tazer, Руководство пользователя, Страница: 34 / 88

Push the pinion towards the main gear and tighten the upper bolts securing
the bearing block. You’re looking for a tight, no backlash mesh, but the
system should still spin freely. Tighten the bolts securing the pinion plate
to the frames, again ensuring that the gear mesh is nice and tight, but freely
spinning. Remove each bolt, one at a time, apply loctite and reinstall.
Slip the belt over the motor pulley and push the motor to the rear,
tightening the belt. While holding the motor to the rear, tighten the 4 bolts
securing the motor plate to the frames. The belt deflection should be
between 1/8” to ¼”. Remove each bolt, one at a time, apply loctite and
reinstall. Spin the main gear ensuring that the belt doesn’t roll off of the
motor pulley, the belt does not have to be centered on the flanged pulley,
but it should not be trying to ride up on the flange either. It may be
necessary to raise or lower the pulley on the motor, or raise or lower the
shaft through the pinion plate by adjusting the collars on top and bottom.
Build the swashplate next from bag 6, start with the outer ring, installing
short balls into each leg, with loctite.