Bercomac 700360-6, Руководство пользователя

Страница: 16 / 36

14
OPERATION
MAINTENANCE
a) Check mounting bolts at frequent intervals for
proper tightness in order to prevent costly repairs.
Make sure your snowblower is in safe working
condition.
b) Provide adequate blocking before working under
the snowblower when in raised position.
ADJUSTMENTS
SKID SHOE ADJUSTMENT:
Level Paved Surface: Adjust skid shoes to allow 3/16" to
1/4" clearance between cutting edge and surface.
Uneven or Gravel Surface: Adjust skid shoes to allow
1/2" to 5/8" clearance between cutting edge and
surface.
LUBRICATION
Grease the wheel axles, the fork pivots after every
sixteen hours of use.
Apply oil at all pivot points.
Chute Rotation System: Oil chute base, rotation worm
every sixteen hours of operation.
Gear box:
Check the oil annually. If necessary, add AGMA 5 EP or
SAE 90 oil.
The gear box should have a total of 155 ml of oil or filled
to the rim of the bolt hole when installed on the
snowblower.
MAINTENANCE
CUTTING EDGE MAINTENANCE
Verify from time to time the wearing on the cutting
edge to make sure you do not wear out the base of
the snowblower’s chassis. This cutting edge is
reversible.
AUGER AND FAN SHEAR BOLT
REPLACEMENT
*Shear bolts are to be considered a preventive
measure and not an assured protection. Operator
vigilance is required. Thoroughly inspect the areas
where the snowblower is to be used and remove all
foreign objects.
To avoid damage to the snowblower:
Use only the original shear bolts (grooved bolts).
#104000 in bags of 10 for both sections of auger.
#103999 in bags of 10 for the fan.
Reinstall auger in the position shown.
The use of any other shear bolt will not insure any
protection and may void the warranty.
WARNING
TO PREVENT INJURIES:
Stop the snowblower motor.
Apply parking brake.
Remove the ignition key.
Disconnect the wire from the spark plug(s) and
keep away from spark plug(s) to prevent accidental
starting.
SNOWBLOWER PULLEY REPLACEMENT
or ALIGNMENT:
Clean the parts before aligning or replacing the pulley.
Apply some "Loctite" 2760 on the key and the set
screws. Tighten firmly.