11
ASSEMBLY
VERIFY BELT ROUTING:
-Lower the snowblower to the ground and let it run for
a few seconds under supervision.
-Disengage the snowblower and stop the engine.
-Remove the belt guard.
-Check the belts to make sure they are well inserted
on the pulleys and have not flipped on their sides in
the pulleys and that they do not touch the belt
guides.
-Reinstall the belt guard.
Insert the handgrip (item 1) on the handle (item 2).
Insert the handle (item 2) through the support (item 3)
as shown.
Insert the handle (item 2) in the rotation worm (item 5)
and secure with a 2.5 mm. hair pin (item 4).
VERIFY SKID SHOE ADJUSTMENT:
LEVEL PAVED SURFACE: Adjust skid shoes to allow
3/16" to 1/4" clearance (A) between cutting edge and
surface.
UNEVEN OR GRAVEL SURFACE: Adjust skid shoes
to allow 1/2" to 5/8" clearance (A) between cutting
edge and surface.
VERIFY TIRE PRESSURE:
Attachments should raise 3" to 4" above ground (no
more, no less) if not, check and adjust tractor tire
pressure as follows:
Front tires:
14-15 psi
Back tires:
7-8 psi
Tire pressure must be even on both sides of tractor.
Install handle
Adjust skid shoes
