1. Remove the prefitted 2 x M8 x 16mm Hex Bolts (69) and then loosely
attach the Weight Cover Tube (24) to the Weight Guide Tubes (17).
2. Attach the Main Upright Frame (8) to the Base Frame (1), using two
M10 x 70mm Hex Bolts (63), four M10 Flat Washers (72) and two M10
Nylon Nuts (76).
3. Remove two M10 x 20mm Hex Bolts (66) and two M10 Flat Washers (72)
from Weight Guide Tube (17).
4.Attach the Upper Cross Beam (7) to the Weight Guide Tubes (17), using
M10 x 20mm Hex Bolts (66) and two M10 Flat Washers (72).
5. Attach the Upper Cross Beam (7) to the Main Upright Frame (8), using
two M10 x 70mm Hex Bolts (63), four M10 Flat Washers (72) and two
M10 Nylon Nuts (76).
Note: Slide the Upper Weight Cover Tube (24) to its highest point and re-fasten
the two M8 X 16mm Hex Bolts (69).
Only fully tighten all frame
nuts and bolts when Parts
7 and 8 are fitted correctly.
Note
Page
Содержание V-fit-ST CUG-2
