Bentone B 55-2, Инструкция по установке и обслуживанию

Страница: 23 / 44

23
Bentone
165 205 36
6. Maintenance
6.1 Servicing the burner device
Removal and fi tting
1. Switch off the mains power.
2. Remove the nuts (H) and pull the burner body out of the guides from
the burner fl ange.
3. Remove the brake plate from the oil pipe and clean the brake plate.
4. Unscrew the nozzle.
5. Fit the nozzle.
6. Install the brake plate. (refer to Technical data)
7. Check the ignition electrodes. (refer to Technical data)
8. If necessary, replace the ignition electrodes.
9. Fit the burner body and the burner fl ange together and secure with the
nuts (H).
10. Open the boiler/spectacle fl ange to access the burner pipe.
11. Remove and clean the burner pipe.
12. Install the burner pipe, make sure you install the drainage hole (not on
all burner pipes) facing downwards so that any spilled oil can drain out.
13. Close the boiler / spectacle fl ange.
14. Turn on the mains power.
15. Check combustion*.
! Use caution when
operating the burner,
surfaces may be hot.
!
When soiled, always
replace nozzles with new
nozzles.
Note:
* When servicing/replacing components that affect combustion, an
analysis and soot test must be carried out on the installation
!
If the burner is directly connected, ensure that all components on
the burner are without power.
H
G
H