AMB10 - 15 - 20
ENGLISH
ISFSLIMRFWL_05_08.doc
12
5.2 Settings and adjustments
Only enable connected beams, proceeding as follows:
a) identify beam to be employed (2, 3, 4) by means of the jumper provided in the TX and RX sensors, bearing in
mind that each beam is actually made up of a two-way (out-going and in-coming) beam cluster (see section 4 for
further details);
b
) set to
OFF
the “BEAM” dip switches of the beams employed located in the MASTER card, which is identified
by the presence of the buzzer.
Beam enabling DIP
BEAM dip switch
Off-board 3.6V power pack
connector
12VDC-
powering
terminal strip
AA
3.6V 2.7Ah
battery
NO TMP1 opening protection
jumper
NO TMP2 tear-off
protection jumper
Supervision signal
enabling jumper
Reset button
Radio Alignment
Button
Alarm mode selection DIP
FUNCTION dip switch
Buzzer
RADIO module
Beam 2, 3, or
4 selection
