Bentel Security Omnia 8/L, Руководство пользователя

Страница: 8 / 12

Power supply connection
The Omnia8/L Panel is powered by the Mains source (230 V/50 Hz) through
an on-board power supply. The Mains wires must be connected to the termi-
nals
(11)
and the battery must be connected to the connectors
(14)
.
On power up----the green LED Main (on the Panel) will go
ON
.
The red LEDs:
Battery
Fuse
Communicator
Communication Bus----will all go
OFF
.
+
On power up (Panel Open)----the OPEN LED on the keypad will go
ON
but the
Panel will not generate a
Tamper Alarm
. However, once the Panel is closed
a
Tamper Alarm
will be generated if the Panel is reopened.
The battery (13.8 V, 7 Ah max. not supplied) will supply the power during
mains failure. Mains failure will be signalled as follows:
Ø
The
MAIN
LED on the Panel will go
OFF
.
Ø
The
TROUBLE
LED on the Control Keypad will go
ON
.
Ø
Activation of one of the auxiliary outputs: 39[O1], 40[O2], 41[O3], 42[O4]----if
programmed to signal
TROUBLE
.
The cause of trouble must always be eliminated before the battery emp-
ties. Total power failure (mains and battery) will not affect the configuration,
as the non-volatile memory will save any changes made during Armed
status.
Open Panel
Access the programming phase before opening the Panel for servicing,
testing etc., as this will disable the tamper microswitch.
Step 1
Enter
INSTALLER PIN
.
Step 2
Press to access programming.
Step 3
Open the Panel.
or
Step 1
Enter
MAIN USER PIN
.
Step 2
Press .
8
Security System Control panel
Omnia 8/L