Bentel Security B3G-220, Руководство по установке

Страница: 55 / 64

220 Series 55
APPENDIX
Conformity with EN 50136-2:2013
To be compliant with EN50136-2:2013, the communicator must be configured and connected to a burglary alarm panel in one of
the two following ways (A and B) only:
A) PSTN connection (the panel must monitor the receiver's response directly via PSTN)
 PSTN: The communicator's
LI
terminals are connected to the panel's external phone line terminals.
 Terminal
T4
, configured as the Tamper output, is connected to the panel input (models with plastic housing only).
 Terminal
T5
, configured as the GSM Fault output, is connected to the panel input.
 Terminal
T3
configured as Interconnection Present, is connected to the panel signal, to report that the panel is present,
or phone line present signal.
 Terminal
T6
, configured as IP Receiver Communications Failure, is connected to the panel's Jamming input.

In the communicator's programming page
IP Receivers
—specify an IP receiver.
B) no PSTN

Terminal
T4
, configured as the Jamming output, is connected to the panel input (models with plastic housing only).

Terminal
T5
, configured as the GSM Fault output, is connected to the panel input.

Terminal
T1
, configured as the Alarm/Tamper input, is connected to the panel's intrusion alarm/tamper output.

Input 1 Event is used to send the intrusion alarm code.

Terminal
T2
, configured as an input, is connected to the panel's fault output.

Input 2 Event is used to send the fault code.

Terminal
T6
, configured as IP Receiver Communications Failure, is connected to the panel's input.
 Terminal
T3
configured as Interconnection Present, is connected to the panel signal, to report that the panel is present.
 The communicator's earth terminal must be connected to a panel input, to detect the connection between the panel and the
communicator.

In the communicator page
Central Station Calls
, for the two events
Input 1 Event
and
Input 2 Event
, set a
Customer
Code
and set
Channel Type
to
CID/SIA: over Data Network
. In the
IP Receivers
page, specify an IP receiver.