TELEPHONE OPERATIONS
If your Installer has enabled the User PINs, you will be
able to control your system via any touch-phone.
+
For recording the customized voice messages,
your system has a
AS100
Stand-alone Audio station.
Each PIN can be programmed to control specific func-
tions and Partitions.
+
PIN N. 1 CANNOT access the system by tele-
phone.
You can access the system over the phone:
Ø
by receiving a call from the Control panel (Dialler
mode);
Ø
by calling the Control panel, when the Answering de-
vice facility is enabled (Answer mode).
Remote Access via Dialler mode
If your installer has duly set up your Control panel, the
Dialler will send voice messages to the programmed
telephone numbers when Alarm, Tamper, Fault condi-
tions are detected. If you receive a Dialler call, you will
be able to access your system during the call by enter-
ing your
PIN
on the telephone keypad. You can enter
your
PIN
while the message is playing, or during the
pauses between message announcements.
+
If the
Confirm successful calls
option is Enabled,
you must press the
*
(Star) key while the voice
message is still running, otherwise the Control
panel will consider the call “Unsuccessful”, and will
carry out the programmed Actions.
Remote Access via Answer mode
If your installer has set up your Control panel to answer
incoming calls, you will be able to access your system
via the
Answering device
facility.
+
The Answering function must be Enabled (refer to
“OPERATING
YOUR
SYSTEM
FROM
A
KEYPAD>Program>ON/OFF
Answering
(2.1)”,
otherwise, you will be unable to access your sys-
tem via remote telephone.
+
DO NOT use a telephone with a redial button to
Arm or Disarm your system, as this may put your
system security at risk.
The Control Panel will answer your call after the pro-
grammed number of rings, then will play the
Welcome
message
and asks you to enter your PIN to access to
the remote control.
Typing-in your User PIN
You can type-in your PIN while the message is playing,
or during the pauses between message announce-
ments, regardless of the Telephone Access mode
(Dialler or Answer Mode). To type-in your PIN:
1.
Press
#
.
2.
Enter your PIN.
3.
Press
#
.
+
If the Vocal Guide is disabled, when your system
recognizes your PIN, it will emit an audible feed
back signal (beep, beep), and will accept com-
mands. If your system DOES NOT recognize your
PIN, it will emit an audible error signal (boop).
+
If the Vocal Guide is enabled, a series of messages
explains the procedures for operating the system
from a telephone. The Vocal Guide must be en-
abled by the Installer.
+
Press
#
to repeat the messages from the start.
+
If you type 10 invalid PINs into the Control Panel, a
tamper is generated and access to the system via
telephone is blocked for 90 seconds: the keypad
will display
Tel. inval.attem
in signal display
mode.
The system will end the call automatically, if no valid
PIN is entered within 30 seconds (at default). This inter-
val can be customized from 1 to 254 seconds.
ABSOLUTA
TELEPHONE OPERATIONS
55
Содержание ABSOLUTA ABS104M50
Страница 67: ......
