62
Important safety instructions
Resetting the lamp timer
Do not reset the lamp timer if the lamp has not been replaced as this could cause damage.
14. After the start-up logo, press
MENU/EXIT
and then press / until the
Advanced Setup
menu
is highlighted.
15. Press to highlight
Lamp Settings
and press
MODE/ENTER
. The
Lamp Settings
page displays.
16. Highlight
Reset Lamp Timer
and press
MODE/ENTER
. A warning message displays asking if you
want to reset the lamp timer. Highlight
Reset
and press
MODE/ENTER
. The lamp time will be
reset to "0".
7. Use the handle to slowly pull lamp housing out of the
projector.
• Pulling it too quickly may cause the lamp to break and scatter
broken glass in the projector.
• Do not place the lamp in locations where water might splash on
it, children can reach it, or near flammable materials.
• Do not insert your hands into the projector after the lamp is
removed. If you touch the optical components inside, it could
cause color unevenness and distortion of the projected images.
8. Carefully lower the new lamp housing to slide it from left to
right into the lamp compartment, as illustrated.
• Be careful not to damage the sides of the new lamp housing
while lowering the whole assembly.
9. Tighten the screw that secures the lamp.
10. Ensure the handle is fully laid flat and locked in place.
• Loose screw may cause a bad connection, which could result in
malfunction.
• Do not over tighten the screw.
11. Replace the lamp cover on the projector.
12. Tighten the screw that secures the lamp cover.
• Loose screw may cause a bad connection, which could result in
malfunction.
• Do not over tighten the screw.
13. Connect the power and restart the projector.
2
2
1
1
1
2
2
3
1
2
1
Содержание W1500
Страница 1: ...W1500 Digital Projector Home Cinema Series User Manual ...
Страница 3: ...3 Table of contents Warranty and Copyright information 72 ...
Страница 4: ...4 Table of contents ...