Step 2: Mounting the ATC Keypad
Cut out the template from the last page of this manual.
•
Tape the template to the dash where you intend to mount the Keypad. (Make
•
sure it is within 6 feet of the Control Unit.) Check behind panel for wires or
obstruction.
Drill a 3/4" hole for the ATC Keypad cable and two 3/16th-inch holes for the
•
mounting screws.
Connect the ATC Keypad Cable to the
•
Keypad. Apply a thin bead of silicone sealant
around the perimeter of the Keypad back. Use
the two enclosed thumb nuts to secure the
Keypad to the dash.
Plug the ATC Keypad Cable into the Control Unit marked “ATC Keypad.” You
•
can use either of the two ATC Keypad connectors. The extra connector is for an
additional Keypad for an upper station.
Step 3: Connecting the ATC Power Pigtail
Connect the orange wire to a 12 volt positive (+) power source that is
•
switched “on” with the ignition.
Connect the black wire to ground (-).
•
Do not plug the ATC Power Pigtail into the Control Unit yet.
•
Step 4: Connecting the ATC Control Unit to the Trim Tab Manual Control
Remove your existing Manual Control from the dash.
•
Disconnect the
•
Red, Green, Yellow and Blue
wires from the back of
the Manual Control.
Do not disconnect the Orange power wire.
•
However, replace the
Orange wire in-line fuse and use the enclosed
1.5
amp fuse.
Trim the wires of the enclosed
•
6-foot ATC 4-Color Wire Harness
to length
and strip the wire ends.
Crimp the enclosed ring terminals to the ATC 4-color Wire Harness.
•
Connect the wires to the back of the control — Red wire to “R,” Green wire
•
to “G,” Yellow wire to “Y,” and Blue wire to “B.”
Reinstall the Manual Control.
•
Plug the Wire Harness into the Control Unit connection marked
•
“
Manual Control
.”
9
This pdf was downloaded from
MarineSupplyDock.com
