AUTO TAB CONTROL (ATC)
INSTALLATION INSTRUCTIONS
IMPORTANT:
Plan how you will lay out the system.
Consider
the wire runs from the Keypad to the Control Unit.
Make sure battery power
is disconnected!
For Non-Electronic Bennett Trim Tab Control Systems
(Rocker Switch Control, Single Lever Control and Racing Type Control)
Step 1: Mounting the Control Unit
NOTE: The Control Unit MUST be mounted properly for the system to work
correctly.
Mount the Control Unit with the following guidelines:
Location:
•
Mount within 6 feet of the
ATC Keypad. (ATC Keypad Cable is 6' long.)
Minimum Vibration:
•
Mount on a
surface that is free of excessive vibration.
Dry Environment:
•
Mount the Control
Unit in a dry location.
Level Surface:
•
Mount the Control Unit
on a relatively level surface. It is not
necessary to mount the Control Unit on a
perfectly level surface, as setting the Zero
Point will account for some off-level
mounting. However, do not mount the
Control Unit at an angle, upside down or vertically.
Pointing Forward:
•
Align the arrow on the top of the Control Unit parallel with
the direction of the centerline (Keel) of the boat.
(Refer to Diagram on Page 12)
8
5($'),567
$OLJQWKHDUURZRQWKHWRSRIWKH
&RQWURO8QLWZLWKWKHGLUHFWLRQRIWKH
FHQWHUOLQH.HHORIWKHERDW'RQRW
DQJOHWRZDUGVWKHERZ0RXQWLQDGU\
ORFDWLRQRQDKRUL]RQWDOVXUIDFHIUHH
RIH[FHVVLYHYLEUDWLRQ
%2:
This pdf was downloaded from
MarineSupplyDock.com
