Beninca CP.BULL8 OM, Руководство пользователя

Страница: 13 / 48

13
CP.BULL8 CoNTRoL UNiT
WiRE diAGRAm
Wire connections shown in Fig. 1 are described hereunder:
Terminals Function description
L/N Power supply
CP.BULL8: Input, 230Vac 50Hz (L-Phase/N-Neutral)
CP.BULL8 115: Input, 115Vac 60Hz (L-Phase/N-Neutral)
GND GND Earth (compulsory)
ANT/SHIELD Antenna
Connection of the antenna to the integrated radio-receiver module
(ANT-signal/SHIELD-screen).
COMMON +12V Common for control inputs.
PP Step-by-Step
Input, step-by-step push-button (N.O. contact)
Presettable as Input, OPEN with OPCL logics.
PED PEDESTRIAN
Input, pedestrian push-button (N.O. contact). It controls the partial opening,
configurable through parameter TPED. At end of TCA time (if activated), closure
control signal is sent. Presettable as Input, CLOSE with OPCL logics.
STOP STOP Input, STOP push-button (N.C. contact)
PHOT O PHO
Input, (N.C. contact) for safety devices (e.g. photocells).
During closure: if the contact is opened, the motor stops. With OPCL logics, when
the photocell is no longer obscured, the motor reversion occurs (gate opens).
During opening: if the contact is opened, the motor stops. with OPCL logics When
the photocell is no longer obscured, the motor restarts opening.
PHOT C PHA
Input, (N.C. contact) for safety devices (e.g. photocells).
During closure: it can be preset by PHTC logics.
During opening: it can be preset by PHTC logics.
+12V COMMON Common for control inputs.
BAR/BAR
SENSITIVE
EDGE
Input, safety edge (Normally Closed contact).
Resistive edge: Jumper “DAS” closed
Mechanical edge: Jumper “DAS” open
If the edge is activated, the gate stops and a movement reversion occurs for about
3 sec.
If the edge is not in use: Jumper “DAS” open, jumper between terminals BAR/
BAR.
SCA
Service light
RX 2° Ch
PHOTO TEST
Free, N.O. contact. Presettable as:
- SCA (open gate indicator lamp): open contact when gate is closed,
fast flashing light when gate is closing, slow flashing light when gate is
opening and closed contact when gate is open. See wire diagram, Fig.2).
(Logics 2CH:OFF, SERL:OFF, TST1:OFF, TST2 :OFF);
- Timed service light (see SERL logics and diagram in Fig.2);
- Output, second radio channel (see 2CH logics and diagram in Fig.2);
- PHOTO TEST to power the transmitters of photocells in TEST mode (see TST1,
TST2 logics and diagram in Fig.3).
24Vac 24Vac Output, power supply of accessories, 24Vac/500mA max
TEChNiCAL dATA
Control Unit supply 230 Vac 50/60 Hz or 115Vac 50/60Hz according to the version
Output supply 1 motor 230Vac
Power maximum motor 280 W
Output supply accessories 24Vac 500mA max.
Protection level IP54
Operating temp. -20°C / +70°C
Radio receiver
built in 433,92 MHz confgurabile (rolling-code or progra rolling-code)
Rolling code transmitters supported 64 rolling-code