BENDIXKing E Series Lawrence, Руководство по программированию

Страница: 3 / 29

KEYBOARD PROGRAMMING
This section describes the procedures for programming Bendix/King
radios equipped with a keyboard and LCD display. Most of these
procedures are the same for diff erent types and models, with exceptions
noted where necessary. Required
equipment includes:
Portable radios --------------- programming plug or cloning cable
ENB and LMH mobiles ----- cloning cable
EMV and EMH mobiles-----
LAA0290 keyboard microphone, when
1 .
2 .
3 .
4 .
5 .
6 .
7..
8 .
available
Remove the covers from the side
connector and the keyboard/display.
Attach a charged battery pack
(portables) or 12V DC power source
(mobiles).
Insert the programming plug or cloning
cable into the side connector
(portables) or mic connector (mobiles).
Select the channel group to be
programmed.
(Not necessary in 14-channel radios.)
See Selecting a Group” on page 19.
Press and hold the master switch.
EMV and EMH: press and hold the far
right button on the front of the radio.
While holding the master switch, press
and hold the
[FCN] key. After
approximately three seconds the LCD
will display - - - ID.
Release the [FCN] key and the master
switch. The radio is now in the
password entry mode.
LPH & LMH: no password function-
skip steps 8 - 10.
Enter the six-digit password code.
Without the correct password code,,
you cannot proceed with programming.