27
Battery Type
Use the following type and size of BATTERY PACK:
Cordless Telephone BATTERY PACK
3.6V, 600mAh
U.S. Electronics Inc.
Ni-Cd BATTERY PACK: Model B658
Ni-Cd
This BATTERY PACK is available through:
U.S. Electronics Service Center
105 Madison Avenue
New York, NY 10016
1-800-828-5208
NOTES:
1. During a power interruption, the BASE UNIT does not operate, and a phone
conversation cannot be made on the HANDSET.
2. To ensure your phone charges properly, place the HANDSET securely
TELEPHONE KEYPAD face up on the BASE UNIT.
Recharging the BATTERY PACK
The nickel cadmium (Ni-Cd) BATTERY PACK in the
HANDSET
can be recharged many times
using the built-in charger in the
BASE UNIT
.
When the LCD Screen display “LOW BATTERY,” the BATTERY PACK needs to be recharged.
Charge the BATTERY PACK at least once every 90 days of non-use to avoid battery failure.
When the BATTERY PACK can no longer be charged, replacement of the BATTERY PACK will
be necessary.
The BATTERY PACK used in your telephone may develop a condition known as “MEMORY.”
Once subjected to a regular short discharging routine, the BATTERY PACK assumes the
discharging pattern it was subjected to. This causes rapid discharging thereby shortening the
BATTERY PACK charge span. If you believe your BATTERY PACK has developed a
“MEMORY” condition, do not charge the
HANDSET
until “LOW BATTERY” appear on the LCD
Screen. When “LOW BATTERY” appears on the LCD Screen, then charge the
HANDSET
fully
for 12 hours.
IMPORTANT
In order to get maximum life from the HANDSET
BATTERY PACK, be sure to charge the
HANDSET for 12 hours before initial use.
Recharging the BATTERY PACK
manual 5815 analog.qxd 3/16/2004 2:40 PM Page 34
