Desk Mounting
8
Desk Mounting
One of the special features of your telephone is the unique design of the MOUNTING
BRACKET which can hold your phone at an angle of 30° when desk mounting. There are two
positions to choose from:
1.
NORMAL POSITION (MOUNTING BRACKET not required):
For normal position, as shown in Figure 1, place
the
BASE UNIT
on any desired but suitable
location.
2.
30° POSITION (See Figure 2):
With the back of the
BASE UNIT
facing up, insert
the hooks of the MOUNTING BRACKET (following
the arrow direction for the DESK MOUNT) into the
slots of the
BASE UNIT
(as shown in Figure 3).
Then slide the MOUNTING BRACKET upward
until it locks into place.
NOTE:
Attach the MOUNTING BRACKET when
using your phone on the desk.
Wall Mounting
You may choose to put the
BASE UNIT
of your cordless telephone on a wall.
1.
With the back of the
BASE UNIT
facing up, connect
the SHORT TELEPHONE LINE CORD to the
TELEPHONE LINE CONNECTION JACK.
2.
Insert the free end of the SHORT TELEPHONE
LINE CORD through the hole of the MOUNTING
BRACKET.
3.
Insert the hooks of the MOUNTING BRACKET
into the matching slots on the back of the
BASE
UNIT
(following the arrow direction for the WALL
MOUNT) then slide the MOUNTING BRACKET until
it locks into place.
4.
Plug the free end of the SHORT TELEPHONE LINE
CORD into the MODULAR WALL JACK.
5.
Align the upper keyhole of the MOUNTING BRACKET
with the upper stud of the wall plate, so that the
opening end of the MOUNTING BRACKET matches
the lower stud, then pull the
BASE UNIT
down until
it is securely seated.
6.
Pull out the
HANDSET
RETAINER TAB on the
BASE UNIT
, then place the
HANDSET
in the
BASE
UNIT
CHARGE CRADLE.
FIGURE 2
FIGURE 3
MOUNTING
BRACKET
MODULAR
WALL JACK
WALL
PLATE
WALL PLATE STUD
SHORT TELEPHONE
LINE CORD
1
2
4
5
5
3
3
3
3
FIGURE 1
manual 5815 analog.qxd 3/16/2004 2:40 PM Page 15
