20929_8820-00034_F6D4230-4_Enhanced_Router_User_Manual_111008 clean.doc
Page 99 of 114
2.
Unplug the cable or DSL modem from its power source for three minutes.
After three minutes, plug the modem back into its power source. This may
force the modem to properly recognize the Router.
3.
Unplug the power to your Router, wait 10 seconds, and then reconnect the
power. This will cause the Router to reattempt communication with the
modem. If the “modem” LED on the Router is not lit after completing these
steps, please contact Belkin Technical Support.
4.
Try shutting down and restarting your computer.
•
The Setup Assistant completed installation, but my web browser
doesn’t work.
•
I am unable to connect to the Internet. The “modem” LED on my Router
is on, and the “internet” LED is blinking.
1.
If you cannot connect to the Internet, the “modem” LED is on, and the
“internet” LED is blinking, the problem may be that your connection type may
not match the ISP’s connection.
2.
If you have a “static IP address” connection, your ISP must assign you the IP
address, subnet mask, and gateway address. Please refer to the section
entitled “Alternate Setup Method” for details on changing this setting.
3.
If you have a “PPPoE” connection, your ISP will assign you a user name and
password and sometimes a service name. Make sure the Router’s connection
type is configured to PPPoE and the settings are entered properly. Please
refer to the section entitled “Alternate Setup Method” for details on changing
this setting.
